The patented product--Shaft chain type edging machine

The shaft chain edging machine independently developed by the company has obtained the patent certificate issued by the

State Intellectual Property Office.

The patented product has been well received by users since it was put on the market. Based on the chain machine and bearing machine, it truly reflects its cost performance：

1. The shaft chain machine with the front and rear splints of the shaft chain structure integrates the

advantages of the conventional bearing machine and the chain machine, and solves the shortcomings of the bearing machine

and the chain machine.

2. The bearing is used as a guide, the chain is used as a power transmission part, and the plane sliding contact between the glass splint and the insert is used as the positioning reference.

3. The organic combination of guiding, power and positioning with relatively independent functions improves the

reliability of the machine transmission and the positioning flatness of the glass plywood, and greatly reduces the maintenance

and use costs.

4. It is suitable for glass grinding with clamping small pieces of 30×30mm and above.

5. The shaft chain machine with this structure solves the disadvantage of the inconsistency of the rolling contact positioning

reference of the splint positioned by the bearing and the insert line in the common bearing machine.

6. The shaft chain machine with this structure solves the shortcomings of easy bearing damage and high maintenance cost

caused by the common bearing machine using the bearing as both a guide and a power transmission component.

7. The front and rear splints of the shaft chain structure are processed by flat grinding, and the plane sliding friction is

used during use, which alwaysensures the consistency of the thickness of the splint

(Conventional bearing machine: there is a bearing but no chain,the bearing is used for both positioning and guiding and

power transmission components.

The fundamental disadvantage is that the positioning of the bearing and the insert is linear positioning, the positioning is

unreliable, the straightness of the ground glass is not good, and the Bearings are easily damaged and maintenance costs are high.

For conventional chain machines, only the chain has no bearings, so the guide friction resistance is large and the running stability is poor.)